ROTO 85cc FS Inline engine with Starter/E-Controller GST Inc (AUS Warehouse)

Description:

Regarding Roto Motor 85cc FS inline engine (Production & Testing around 20 days)

for hobby industry, modellers only need the version with starter/generator (carby version) Config 85D 

• There are up to 18 configurations for different solutions. 
• The engine has carby version and EFI (Electronic Fuel Injection)
• There are two generator in 400W and 1000W and Voltage regulator in two voltage outputs

Rotomotor makes one key starter (STG/Starter) and EPU (Electric Power Unit)/generator in 1000W and 2000W

STG-EPU (Start Generator-Electric Power Unit)

Rotomotor makes E-Control  which Is designed to remote starter, turbo mode, charge and use battery from 12S Lipo battery for the project (servo, RX, camera Gimbal, task payload etc). This is the best solution to integrate other gears (One Key starter/EPU) for long endurance and battery life time circle. It is very useful for both carby version and EFi version

E-Control is an electronic system designed to control  the motor generator, which allows the start of the internal combustion engine, charging batteries and hybrid operation, increasing the power of the internal combustion engine

2.1 Absolute Maximum Ratings

Operating temperature: -20°C to +80°C

Non-operational voltage: 9 - 60V DC

Charging current: 45A

Peak power (10 sec): 4300W

Peak current (10 sec): 100A

Safe voltage: 11 - 55V DC

Operating voltage: 12 - 51V DC

Battery configuration: 12 S

Battery nominal voltage: 43.2V DC

PWM frequency: 20 kHz

Controller thermally connected to infinite heat sink which does not exceed 60°C.

Maximal power dissipation: 20W

Nominal power (60 min): 2200W

Nominal current (60 min): 51A

Controller placed in still air of temperature 25°C.

Maximal power dissipation : 10W

Nominal power (60 min): 1500W

Nominal current (60 min): 35A

BMS (Battery Management System) is used for battery lifetime maintenance, which use Lipo, Li-ion, LifePO4 cells or other cells with operation voltage range 1.8V-5V each cell. BMS provides protection and increase the lifetime of the batteries by measuring its temperature, controlling the voltage and flowed current.

Configuration explanation:

If the customer wants to achieve up to 5000 meter altitude and long endurance and long life time of the battery, select Config 85E or F

• Config 85A      Carby version engine only,
• 
  
• Config 85D      Carby engine+Starter/EPU (ONE KEY STARTER /POWER GENERATOR) 1000W & E-controller
• 
  

Four-stroke two-cylinder petrol internal combustion engine

	Alternator 400W	Alternator 1000W
PMG ( Permanent Magnet Generator)	3 phase output
NdFeB magnets
Voltage curve	14V/1000RPM (possibility of rewinding according to client)
Diameter	101mm
Thickness	22mm	25mm
Weight	450g	550g
Out. Power at 3000RPM	300W	430W
Out. Power at 6000RPM	600W	960W
Cooling	forced by air flow
Resistance	to fuel, oil, water, mechanical stress
Operating temperature	-30°C to 120°C